Painless 3d lessons

I originally set up Painless 3D as a blog to teach my friends 3D through GSculpt. I discovered that very little documentation exists on GSculpt other than Britefury’s main Gsculpt website. Over the past few weeks I have put together some GSculpt Tours here and some basic information here on this blog.

It’s a pity that an amazing software like GSculpt doesn’t have as much documentation as it should. I have put up an unofficial (Because Britefury is a rare sighting!) GSculpt resource site here and started a Wiki for documentation here. Right now a lot of content is duplicated from this website and the main GSculpt site, and it has almost close to nothing in terms of content. I’ll start clean ups and filling in the missing pages as and when I have time.

If you are a GSculpt user and would like to help, just comment below or apply at the Wiki.